The Relay Module is intended for use in intelligent, two-wire systems, with inbuilt isolator. This module utilise a single address where the address of each module is selected using the DIP switches. This module is been supervised for the status (Alarm / Normal). Relay Module facilitates third-party devices to interface with Ravel addressable panels. Relay modules are the remote devices to activate / de-activate any device or instrument or unit using potential free contact. The red blinking LED indicates normal operating conditions and the steady state for activated conditions.
The panel status shall be visually indicated in unambiguous color with distinguished inbuilt audible tone. This system can operate as a standalone or connect to 16 network nodes with network interface card
| Electrical Specifications | |||
|---|---|---|---|
| Operating Voltage | 24 VDC Nominal | ||
| Alarm Current | |||
| 2 mA (max) | |||
| Standby Current | 0.7 mA | ||
| Contact Rating | 2 A @ 30 VDC (resistive) | ||
| Contact Type | Form C (Potectial Free Contact) | ||
| Operating Temperature | 0 – 49° C / 32 – 120° F | ||
| Storage Temperature | 0 – 60° C / 32 – 140° F | ||
| Humidit | 93 ± 2% RH (non-condensing) | ||
| Mechanical Specification | |||
|---|---|---|---|
| IP rating | IP 40 | ||
| Dimensions |
(76.6L X 71.6W X 22D) mm (without gang holder) (125.5L X 85.5W X 22.2D) mm (with gang holder) |
||
| Material | FRABS | ||
| Weight | 80 g | ||
