The control module is intended for the use in intelligent two wire system with an inbuilt isolator. The address of each module is selected by using the DIP Switch. The control module is the remote switching device to control 24 VDC devices. It also supervises the wiring connected and reports their status to the panel as (Alarm / Normal / Open / Short / 24V fault). The red blinking LED indicates normal operating condition and the steady state for activated condition.

The panel status shall be visually indicated in unambiguous color with distinguished inbuilt audible tone. This system can operate as a standalone or connect to 16 network nodes with network interface card


  • UL Listed 864 10th edition.
  • Supervised 24 VDC.
  • Status LED.
  • DIP switch for addressing.
  • Address between 1 – 250.
  • Inbuilt isolator.
  • SLC communication with the panel.
  • Single gang box.
    • Electrical Specifications
    Operating Voltage 24 VDC Nominal
    Alarm Current 2 mA (max)
    Standby Current 0.5 mA
    End of Line resistance 47K ½ watt
    Storage Temperature 0 - 60° C
    Wiring Style Class B
    External Supply Voltage Regulated 24 VDC
    External Supply / 24VDC Output Current Max 0.5 A @ 24 VDC
    Voltage Drop 1.2 V
    Temperature Range 0 – 49° C / 32 – 120° F
    Storage Temperature 0 – 60° C / 32 – 140° F
    Humidity 93 ± 2% RH (non-condensing) at 32 ± 2° C / 90 ± 3° F
    Mechanical Specification
    IP rating IP 40
    Dimensions (76.6L X 71.6W X 22D) mm (without gang holder)
    (125.5L X 85.5W X 22.2D) mm (with gang holder)
    Material FRABS
    Weight 80 g
    ...